new member & hopefully new owner soon.
Hi everybody, im Reggie from Hampshire & just joined the forum. Im currently in the process of buying a 2007 230 as providing alls ok after liftout. all seems to be good apart from corroded engine...
View ArticleRe: new member & hopefully new owner soon.
Welcome to the site Reggie, stacks of info on here but you seem to have the bases covered. I have not had wipers on my 250 for four years. Just keep the windows clean and give them a regular dose of...
View ArticleRe: new member & hopefully new owner soon.
Hi Reggie,Echo Andy's welcome.As Andy say's, you have bases covered.. Cutlass bearing, rudder, seascoops and any signs of damage..Gas struts are available from £25 each. (Others here may know of other...
View ArticleRe: new member & hopefully new owner soon.
Thanks for the welcome Andy. There is a lot of useful info here! This Rainx stuff must be really good if you don't need wipers, ill try it before renewing the motors. the boat will be kept at...
View ArticleClik here to view.
Re: new member & hopefully new owner soon.
Can I suggest you also try "Pledge" the polish... Good old squirt on the screen, and a gentle "spreading" of it over the screen. Within seconds it dries and becomes clear..The result is water just runs...
View ArticleRe: new member & hopefully new owner soon.
Thanks for your welcome too Dave, I may take you up on the gas struts later on. Im unsure of which kind of shaft seal it has but, the previous owner says it is totally maintenance free that's all I...
View ArticleRe: new member & hopefully new owner soon.
Hi Reggie Welcome to the site hope you get afloat soon !Stuart
View ArticleRe: new member & hopefully new owner soon.
Hi Stuart ,thanks for the welcome. if all goes well it shouldn't be too long. Ill keep you all posted.Regards Reggie.
View ArticleClik here to view.
Re: new member & hopefully new owner soon.
230as update. its been lifted out now & apart from a good cleanup that's needed, (now purchased & joint owned ) there is some small amount of play on the rudder shaft although it was not...
View Article
